Notifications
Clear all
Nozzle fan not working during a print
Hello everyone,,
When performing a self test the nozzle fan spins up no problem but then whilst printing it doe's not work at all. In the "Tune" menu it shows the fan speed is set to "255" (max speed) but the fan is not spinning. Slicer has fan set to always on and I have tried a S3D file also with the same results so this must be a firmware or hardware bug? Anyone else seen this issue?????
Posted : 17/12/2019 6:52 am
RE: Nozzle fan not working during a print
Check again that both fans are connected to the correct sockets on the control board and in the correct orientation.
Bill
Tagaytay City, Philippines
Founder member of Philippines Prusa Printer Owners FB Group
Sponsor Pillars of God Academy in Bacoor
Posted : 17/12/2019 7:37 am