Is there a 7x7 option available for 3.60?
I upgraded to the latest 7x7 fork that was posted, and it drove one of my machines batty.. the extruder starts clicking about 20 minutes into a print, and no matter what temp, or speed, it just wouldn't print. I went back to stock 3.6.0, and all is happy again...
I'm confused.. I thought I read that it was enabled in this build, but I cannot find the option for the 7x7 mesh.
It makes a huge difference in my prints.. I mean they were nearly perfect before, but the 7x7 makes pure 1st layer porn!
Any pointers would be appreciated... I've been reading and reading, and it may be right under my nose, but if it is, I've completely missed it!
Thanks guys!
Re: Is there a 7x7 option available for 3.60?
Yes, there is a link in the same thread ... but the verbiage is totally different and hard to find the small link. I want to say around page 11 or 12 ... but it's been a while. It was a link to a raw hex file, not a zip.
Re: Is there a 7x7 option available for 3.60?
3.7.0 has 7x7 selectable via the LCD menus...
Re: Is there a 7x7 option available for 3.60?
Could you be more specific? Which option, then which suboption?
Re: Is there a 7x7 option available for 3.60?
Settings - Mesh bed leveling ...
Thomas