Notifications
Clear all
Prusa MK2.5 Upgrade Successfully but issues printing after a couple of weeks use
Did the upgrade following all the instructions all went well did a few prints after upgrading the firmware.Have upgraded to firmware 3.7.2 but have the problem of printer displaying Err:MINTEMP BED the first time the printer is switched on and try to preheat.After resetting the printer heats up and starts to print but after a couple of minutes it pauses and the display shows Heating and then after about 3 to 5 secs starts again and keeps repeating.After it has done a 2 or 3 layers the printer moves up and does a change of filament and this keeps repeating every so often. I never had any problems before the upgrade. Has anybody else had this issue and if so hope you can help me. Thanks in advance.
Posted : 03/07/2019 10:35 am
RE: Prusa MK2.5 Upgrade Successfully but issues printing after a couple of weeks use
im suffering same problem any cure yet
Posted : 19/07/2019 10:08 pm