Mk2 to 2.5 upgrade problems
Hello All,
We I've been waiting forever to upgrade my Mk2 to a 2.5 simply because the Mk2 was working so well. Well today was the day.
All went fine until I got to the attachment of the extruder and found that the Splitter cables were all wrong!
See attached.
The new PINDA probe has a 4 pin end.
The filament sensor has 4 pin & 5 pin ends.
But the two splitter cables one has a 4 pin end and the other has a 3 pin end.
I'm super frustrated because I now have neither a Mk2 or a Mk2.5.
Please help if a have a course of action.
Thank you,
Muggs
RE: Mk2 to 2.5 upgrade problems
Is there not enough information here in step 18 to help you? https://manual.prusa3d.com/Guide/5.+Electronics/1075?lang=en#s19050
Bill
Tagaytay City, Philippines
Founder member of Philippines Prusa Printer Owners FB Group
Sponsor Pillars of God Academy in Bacoor