Notifications
Clear all
Issues with bed leveling after owning MK3S+ for a while
Hey all,
I'm struggling to figure out how to fix my issues here. Running the first layer calibration print, it looks like just the center of my bed is too high, while the corners are too low. I've had my printer for a while, but it's just recently started having issues when I try to print anything at the center of my print bed.
I've also included my mesh bed data, which doesn't look too terrible with a variation of 0.17
Is Bed Level Correction the answer? I guess I'm not sure how to tackle the issue being in the center of the bed, versus needing to raise or lower left/right/top/bottom.
Any help would be greatly appreciated!
EDIT: This was printed with Inland Tough PLA, 220/65 first layer, 215/60 for the rest.
This topic was modified 1 week ago by HandelsPariah
Posted : 01/01/2025 3:49 am