Full Bed Printing Help
Hi All, long time printer with a prusa MK2.5s, first time poster.
Let me start with saying I aboustely love the Prusa range and have been with them for the last 5 years, the only thing I have never been able to perfect was being able to utilize the full bed. I'm at the stage where I'm looking at being able to push the build platform limits for some large prints and my first layer is holding me back.
I've tried the bed off set, resurfacing the sheet and just lately switched my mesh leveling from 3x3 to 7x7 but I still can't dial it in. I've attached some pictures of the first layer STL from Prusa trouble shooting and was hoping the community could point me in the right direction of what areas I should focus on and any tips
RE: Full Bed Printing Help
Does the 2.5 have Z 'fudge factors' for left/right and front/rear?
RE: Full Bed Printing Help
Looks like your sheet is just dirty. Do a proper clean and it should run way better. (No, wiping with IPA is not enough.)