https://forum.prusa3d.com/forum/older-machines-prusa-i3-mk1-and-older-how-do-i-print-this-printing-help/ Prusa3D Forum Discussion Board en-US Sat, 07 Mar 2026 14:23:05 +0000 wpForo 60 https://forum.prusa3d.com/forum/older-machines-prusa-i3-mk1-and-older-how-do-i-print-this-printing-help/design-for-support-mesh-needed/ Thu, 31 Aug 2023 14:14:49 +0000 I would like to print such a pot, diameter about 60 mm and height about 100 mm and since there is something else on the top surface, it cannot be printed upside down; the walls are 3 mm all around - How can I design the support so that it is supported laterally on the walls - see the support sketched in yellow in the picture - and what should be a solid angle and what are usefull settings for the support? Thank you very much for your support!

]]> How do I print this? (Printing help) apZ https://forum.prusa3d.com/forum/older-machines-prusa-i3-mk1-and-older-how-do-i-print-this-printing-help/design-for-support-mesh-needed/ https://forum.prusa3d.com/forum/older-machines-prusa-i3-mk1-and-older-how-do-i-print-this-printing-help/pravidelne-posouvani-osy-x/ Thu, 17 Feb 2022 09:51:35 +0000 Dobrý den, prosím o radu,  po každé vrstvě se pravidelně posune při tisku osa x, děkuji

]]> How do I print this? (Printing help) Petr https://forum.prusa3d.com/forum/older-machines-prusa-i3-mk1-and-older-how-do-i-print-this-printing-help/pravidelne-posouvani-osy-x/