Had a good laugh - troubleshooting to follow
 
Notifications
Clear all

Had a good laugh - troubleshooting to follow  

  RSS
David Pease
(@david-pease)
Active Member
Had a good laugh - troubleshooting to follow

Wife sent me this from my first print attempt since updating to the new firmware, guffawed at my desk at the office:

"Did you mean to print this?"

The print queue was for a gcode that was sliced right before updating firmware - I'll look into what went wrong when I get home later this evening.

 

Posted : 20/09/2023 8:51 pm
David Pease
(@david-pease)
Active Member
Topic starter answered:
RE: Had a good laugh - troubleshooting to follow

All is well again!  Not sure what went wrong, but huge speed improvements so far via IS enablement! (I may have forgotten to update the printer settings configs)

Posted : 21/09/2023 2:06 pm
Microtic
(@microtic)
Active Member
RE: Had a good laugh - troubleshooting to follow

 

Posted by: @david-pease

Wife sent me this from my first print attempt since updating to the new firmware, guffawed at my desk at the office:

"Did you mean to print this?"

The print queue was for a gcode that was sliced right before updating firmware - I'll look into what went wrong when I get home later this evening.

 

Ahahaha! Thanks for the laugh. 🤣 🤣 🤣 

Was it actually supposed to be number 2, or just some random lucky occurrence?

Posted : 23/09/2023 11:20 am
David Pease
(@david-pease)
Active Member
Topic starter answered:
RE: Had a good laugh - troubleshooting to follow

Nope! It was meant to be some armor plates for a large robot model.  Just a total failure, as you can see, with an unfortunate choice of filament color.

Posted : 24/09/2023 3:31 am
Microtic liked
szara
(@szara)
Eminent Member
RE: Had a good laugh - troubleshooting to follow

Sorry, but looks like it's impossible to come out like this from a .4mm nozzle!!! Where are the layer lines, should have looked more like spaghetti than poop! It looks like someone took a dump all at once, not what molten filament would look like!

Posted by: @david-pease

Wife sent me this from my first print attempt since updating to the new firmware, guffawed at my desk at the office:

"Did you mean to print this?"

The print queue was for a gcode that was sliced right before updating firmware - I'll look into what went wrong when I get home later this evening.

 

 

Posted : 25/09/2023 2:40 am
Share: