Cannot upload file via PrusaLink after update - Input Shaper (MINI)

RE: Cannot upload file via PrusaLink after update

janicek.trnecka — Mon, 18 Dec 2023 22:09:54 +0000

I am getting both, sometimes connection timeout, sometimes reset.

RE: Cannot upload file via PrusaLink after update

cwbullet — Thu, 26 Oct 2023 17:56:20 +0000

I have installed the firmware on 4 of my printers it work great. No issues with upload.

RE: Cannot upload file via PrusaLink after update

JayMoney — Thu, 26 Oct 2023 17:42:55 +0000

I had that when I was using Octoprint with the alpha but not since just thumb driving directly.

RE:

Lanex — Thu, 26 Oct 2023 17:41:03 +0000

For example, I started a print, calibration was in progress, I stopped the print, everything was fine. Then I sent a new print, and a blue screen of death. Reset, blue screen of death. Reset, blue screen of death. I had to turn printer off, wait, turn it back on, upload again, and it's okay, it's printing.

RE:

mixer3d — Thu, 26 Oct 2023 17:33:57 +0000

At least on my side i don't have any issues with alpha2, and slicer 2.7 alpha (and it's using bgcode).
Before i had problem with wifi, but never had any crash, blue screen etc.

RE: Cannot upload file via PrusaLink after update

JayMoney — Thu, 26 Oct 2023 16:54:28 +0000

Oh not great then. :/

RE: Cannot upload file via PrusaLink after update

Lanex — Thu, 26 Oct 2023 16:52:44 +0000

But it crashes more frequently than Alpha1. But that will certainly be resolved in Alpha3.

RE: Cannot upload file via PrusaLink after update

JayMoney — Thu, 26 Oct 2023 16:41:30 +0000

Oh great! I didn't even see that alpha 2 had been released, I was just confused about the Slicer alpha that was making these weird bgcode files that I couldn't use. :D I'll have to give it a try, thanks!

RE: Cannot upload file via PrusaLink after update

Lanex — Thu, 26 Oct 2023 16:31:20 +0000

I updated to firmware 5.1.0-alpha2, and now I have no problem sending 20 MB files over WiFi. Fantastic! This is what I was looking forward to. Among other things, this firmware supports binary bgcode, which is typically four times smaller than traditional GCode. This means that files are uploaded to the printer much faster than with 4.4.1. It can also stream Gcode, meaning that printing starts right away, and the rest of the file finishes during the print. I haven't seen it in action, either because I print small files or because I need to enable it somewhere in PrusaSlicer 2.7.0 (?). In any case, it's a completely different printer compared to 4.4.1. There's no going back to 4.4.1. :) Good work! Prusa Connect / Prusa Link also works great.

RE: Cannot upload file via PrusaLink after update

mixer3d — Wed, 18 Oct 2023 07:00:49 +0000

Hi i wanted to update, so i checked around and i found in the logs during the gcode sending process and it was complaining about storage, so i removed for test all files with subdirectories from the stick and tried again... and it works :) i can send bigger files... So could be that the issue is related to the handling storage for now, not the upload process itself...