Notifications
Clear all
Start of first layer fill extrusion issues
For each of my prints, when it starts filling the inside of the first layer, the corner extrusion is not completely filled, then the rest of the fill and print looks fine. Honestly I'm fine with how my prints are turning out, but was wondering if this is expected or something with my settings. Maybe retraction settings or some other setting I don't know about?
Posted : 21/11/2022 8:15 pm
You can go a little lower on your first layer Z calibration, a bit more squish.
Cheerio,
Posted : 21/11/2022 11:01 pm
Topic starter
answered:
RE: Start of first layer fill extrusion issues
Thanks I'll give it a shot. Going to feel dumb if that's it, but rest of the first layer looked so good I thought it was fine.
Posted : 21/11/2022 11:24 pm