Notifications
Clear all
Single Line of Extrusion
I want to print text with just a single line of extrusion and one layer height. But the contour will of course always have two walls.
I have chosen a font with straight lines and no serifs. I can remove the infill but I can’t make the settings to just “writing” the text with the nozzle like you would with a pen. Is there such an option in Prusa Slicer or do I need to achieve this by setting up an even thinner font? My Nozzle is 0.4mm. Thanks!
Posted : 01/04/2021 11:51 am
RE: Single Line of Extrusion
Activating the Detect Thin Walls option is your best chance.
I also think 1 layer is not going to give your text much visibility.
Formerly known on this forum as @fuchsr -- until all hell broke loose with the forum software...
Posted : 01/04/2021 12:20 pm