Leftside overhang corners fail? - How do I print this? (Printing help) https://forum.prusa3d.com/forum/how-do-i-print-this-printing-help/leftside-overhang-corners-fail/ Prusa3D Forum Discussion Board en-US Sat, 11 Apr 2026 14:28:51 +0000 wpForo 60 RE: Leftside overhang corners fail? https://forum.prusa3d.com/forum/how-do-i-print-this-printing-help/leftside-overhang-corners-fail/#post-735682 Sat, 08 Feb 2025 15:22:39 +0000 Yaa I forgot about the fits layer ,, but it sticks :-)

Also downloaded the model again cuzz it looks like the one Iwe got wasent from printables.com, resliced it and now its ok, tnx anyways.

 

]]> How do I print this? (Printing help) Unpoor https://forum.prusa3d.com/forum/how-do-i-print-this-printing-help/leftside-overhang-corners-fail/#post-735682 RE: Leftside overhang corners fail? https://forum.prusa3d.com/forum/how-do-i-print-this-printing-help/leftside-overhang-corners-fail/#post-735659 Sat, 08 Feb 2025 13:27:49 +0000 Check where the slicer is putting the seam.  I suspect its that corner.  If so move it elsewhere.  Also printing fast with a mini with thin geometry is asking for problems.  Slow your print speed down.

One other thing, your first layer with the brim is showing masses of drag marks, that means your first layer is squished too much.  You might want to revisit your basic printer calibration and setup.  Double check everything is still square etc.

]]> How do I print this? (Printing help) Neophyl https://forum.prusa3d.com/forum/how-do-i-print-this-printing-help/leftside-overhang-corners-fail/#post-735659 Leftside overhang corners fail? https://forum.prusa3d.com/forum/how-do-i-print-this-printing-help/leftside-overhang-corners-fail/#post-735654 Sat, 08 Feb 2025 12:40:38 +0000 When trying to print https://www.printables.com/model/305814-mak-vector-duct-orbiter-v20-v6-volcano-crealityend/files

the left corner on this modell is impossible to print, tried supports and not, it prints counter clockvise and I use 100mm/s perimiters, inside and outside.

Prusa mini+ 6.2 fw 

Any ideas?

 

 

]]> How do I print this? (Printing help) Unpoor https://forum.prusa3d.com/forum/how-do-i-print-this-printing-help/leftside-overhang-corners-fail/#post-735654