Notifications
Clear all

First Layer Peeling for Particular Print  

  RSS
SAMURAIGUY
(@samuraiguy)
New Member
First Layer Peeling for Particular Print

Hi everyone!

Brand new to 3D printing so bear with me here. So I've been trying to print this model but everytime on the first layer I get these ridges almost like the nozzle is rubbing back over the previous layer. Any suggestions would be appreciated! 

Settings:

PLA Galaxy Silver

Bed Temp 60

Nozzle Temp 215

Quality .15mm

Infill 15%

Clean bed with isoprpyl

Gcode: https://www.myminifactory.com/object/3d-print-ultra-swole-pikachu-109313 scaled to 79%

 

This topic was modified 4 years ago by SAMURAIGUY
Posted : 08/06/2020 10:18 pm
3Dprintedgr
(@3dprintedgr)
Estimable Member
RE: First Layer Peeling for Particular Print

Looks like you need to run a First Layer Calibration your nozzle seems too low and its tearing through the layer. Check this link for more information. You can find First Layer Calibration in the menu on Calibration->First Layer Calibration

https://help.prusa3d.com/en/article/first-layer-calibration_112364

Original Prusa Mini + Smooth PEI
Prusa Slicer 2.6.0

Posted : 14/06/2020 2:34 pm
Share: