Notifications
Clear all

X-Axis crashes in the end at canceled print  

  RSS
Axaroth
(@axaroth)
New Member
X-Axis crashes in the end at canceled print

When i cancel a print , the X-Axis drives in home position but it don´t stops immediately , so you can hear the pulley grinding over the belt . 

Does not happen every time . 
I was still unable to find out a reason why this sometimes happens and sometimes not.

Posted : 10/01/2020 5:35 pm
Crawlerin
(@crawlerin)
Prominent Member
RE: X-Axis crashes in the end at canceled print

Yeah it happens, it is reported on Github too. https://github.com/prusa3d/Prusa-Firmware-Buddy/issues/27

Posted : 11/01/2020 12:50 am
Axaroth
(@axaroth)
New Member
Topic starter answered:
RE: X-Axis crashes in the end at canceled print

@crawlerin

OK thx , i haven't watch in the GitHub page. 

So the next Thing to solve ist the Extrusion issue . 

Posted : 11/01/2020 1:36 pm
Share: