Verifying
loaded in the PrusaMINI PrusamentASA Orange…
in PrusaSlicer but accidentally filament PrusamentPLA set ...
loaded onto the USB ...
plugged into the MINI ...
powered up ...
and ASA preheated ...
after 10 minutes my file selected ...
and waited for the 170 ° level temperature ...
leveling was ok ...
but the printer started printing with the wrong PrusamentPLA profile ... see pictures ...
The question now arises:
PrusaMini shows the medium he has loaded in the lower right corner
PrusaMini shows when selecting the file in the preview for which medium
a comparison in the firmware from profile to filament must be possible now.
I'm thinking of an info box (wrong filament or profile loaded)
that would save some filament waste ...
Nozzel cleaning would also be eliminated ...
unnecessary heating phases are avoided
I once wrote it here ...
can you give suggestions for the firmware elsewhere?
can you give suggestions for the firmware elsewhere?