Notifications
Clear all
Sudden problems printing on a Mini
I've suddenly run into issues with my Mini+. As can seen by this test print, there is banding on the print, which suddenly disappears at the end. The printhead is clean and is at ~ -1.90; the Pinda head is a 'credit card' off the build plate. In spite of washing the PEI plate in soap, rinsing it and drying it, I run into adhesion issues where the print head will 'grab' some of the print and drag it off the plate. I have done a first run calibration and ~ -1.9 appears to be correct.
Any suggestions where to go next. This suddenly happened between prints.
Posted : 01/01/2024 4:40 pm