Notifications
Clear all
Z goes down after first layer
Has anyone experienced Z going down after first layer
Posted : 23/02/2022 10:04 pm
Topic starter
answered:
RE: Z goes down after first layer
Why are you shaming me?
Posted : 24/02/2022 1:27 am
RE: Z goes down after first layer
Huh? I'm just trying to understand what you're seeing. Hard to get quality advice with a cryptic problem description...
Formerly known on this forum as @fuchsr -- until all hell broke loose with the forum software...
Posted : 24/02/2022 1:30 am
RE: Z goes down after first layer
If you had a corexy printer the bed would move down as the z value increased. But now see that this thread in the Mini category then obviously not.
Posted : 24/02/2022 12:14 pm
RE: Z goes down after first layer
Well...depends on the CoreXY setup (see, Voron V2.4 vs Trident).
So to the OP, is what you are seeing the Z dropping down after the first layer? It's not moving up correctly? If so probably a chat with Prusa support.
Mini+ (kit) - Revo Micro | Antler Cooling | WiFi (4.4.0RC1)
Posted : 24/02/2022 3:33 pm