Recovery after a very short (
I had my MINI+ running a 25+ hour print. The power went off for less than 2 seconds and the MINI+ did not recover. In fact the nozzle dug into the print.
Did I miss something or is it not possible for it to recover? This happened to my MK3S+ and did recover.
RE:
MINI does not have power panic and recovery.
https://github.com/prusa3d/Prusa-Firmware-Buddy/issues/677
wbr,
Karl
Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.
RE: Recovery after a very short (
I thought that was the case but was not sure.
Thanks
RE:
Published by Prusa: Future software upgrade, single layer accuracy.
I think that a hardware intervention then also will be necessary.
wbr,
Karl
Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.