Notifications
Clear all
Printing losses after view times
Dear,
The printing is losses after view time and continue printing in the air without touching the model. You can see the attached PIC.
It takes all my time to watch out as its wasting my filament.
This topic was modified 5 years ago by musaihelan
Posted : 20/04/2020 1:28 pm
RE: Printing losses after view times
Do the pre configured prints work?
Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
Posted : 20/04/2020 3:26 pm
Topic starter
answered:
RE: Printing losses after view times
@joantabb
Yes I printed the first time it was good,
The test is good
I printed froggy and some other things and it was perfect, but some items it does the same, just throwing the filaments over the sheet.
Posted : 20/04/2020 3:36 pm
Topic starter
answered:
RE: Printing losses after view times
Posted : 21/04/2020 1:38 pm
Topic starter
answered:
RE: Printing losses after view times
Now I receive watchdog msg and it stop printing and start from beginning....
Posted : 21/04/2020 1:39 pm