Notifications
Clear all
Mini corners.
The vertical corners on both of my minis are not sharp. They are roundish and stick out a bit more than the walls coming up to them. I always have to trim them to go into a square hole. I was wondering what settings I could change to help with this?
Thank you very much.
Barry
Posted : 23/12/2025 9:38 pm
RE:
Try https://www.printables.com/model/641490-prusa-slicer-pressure-advance-test but make sure to read the comments in the makes section.
See my GitHub and printables.com for some 3d stuff that you may like.
Posted : 08/02/2026 7:47 am