Notifications
Clear all

Tearing on first layer, unsure how to fix  

  RSS
CarlosAndrade981
(@carlosandrade981)
Member
Tearing on first layer, unsure how to fix

Hello, I am having trouble printing with Prusament PETG. The first layer seems to tear in almost the same spot, after 4 different attempts, and I am unsure as to why this is happening. I have cleaned the sheet with dawn dish soap and water, but this did not seem to do anything to help. The only change I made between attempts was fixing some overextrusion by lowering the extrusion multiplier. I was able to print a smaller part, that didn't have any material in that spot, without any issues.

 

Posted : 29/05/2025 12:46 am
Share: