Notifications
Clear all
My Bridges Aren't Bridigning! How Do I Print Better Bridges?
I have been reading some stuff online and have tried to tweak some setting to make better bridges, but they STILL sink, are droopy, and are not consistent 🙁
How can I improve this?
Printer: MK4 that was upgraded to an MK4S, using the .4 high flow nozzle, and .2mm detail preset (changes listed below).
Filament: eSUN PLA+ (Link to specific product on amazon)
Here is a list of settings I have changed from default of the .2mm detail preset profile. Attached is a benchmark print photo.
- Other Layer Temps: 210c
- Extra perimeters if needed: Checked
- Seam position: Rear
- Staggered inner seams: Checked
- Bridging angle: 90°
- Don't support bridges: Checked (This was not using supports though!)
- Bridges: 50mm/s (have tried slowing it to 30 mm/s still no changes)
Posted : 11/10/2024 1:43 pm