Stringing issues after upgrading to MK4S - Assembly and first prints troubleshooting https://forum.prusa3d.com/forum/english-forum-original-prusa-i3-mk4s-assembly-and-first-prints-troubleshooting/stringing-issues-after-upgrading-to-mk4s/ Prusa3D Forum Discussion Board en-US Wed, 11 Mar 2026 16:02:14 +0000 wpForo 60 Stringing issues after upgrading to MK4S https://forum.prusa3d.com/forum/english-forum-original-prusa-i3-mk4s-assembly-and-first-prints-troubleshooting/stringing-issues-after-upgrading-to-mk4s/#post-728682 Mon, 02 Dec 2024 03:27:50 +0000 I built my MK4 back in April, and it was printing great, but then I upgraded to the MK4S and I think now that I'm using a high flow nozzle, it's causing a LOT of stringing issues that wasn't there before. Anyone got any good settings to help counter this? I printed a Temp Tower and it showed stringing on almost every layer. Hoping someone has seen this issue and found a fix for it?

]]> Assembly and first prints troubleshooting Gabriel Fricke https://forum.prusa3d.com/forum/english-forum-original-prusa-i3-mk4s-assembly-and-first-prints-troubleshooting/stringing-issues-after-upgrading-to-mk4s/#post-728682