Notifications
Clear all

Perimeter not connecting next to seam  

  RSS
COuimette
(@couimette)
Member
Perimeter not connecting next to seam

I have 2 perimeters set for my prints in prusa slicer. When I have a interior perimeter the one with the seam shows up fine. However, the 2nd perimeter leaves a space and doesn't finish the perimeter line. I use mostly stock prusa settings for 0.2mm QUALITY. I tried increasing extrusion but didn't see any change. Any ideas? Exterior perimeters are fine, its only when I program a cut out in the middle of the piece. 

 

Posted : 03/11/2023 6:58 am
Share: