Notifications
Clear all
Filament change due to spool empty - how
So I got my first time the MK4 ran out of filament. It asked e to change it, so I put new one through the tube (enclosure).
There were roughly 5 cm filament left at the end to the nozzle and I pushed the new filament until there. However now the printer asks me to remove filament from the sensor.
How do I do this? Do I have to unassemble the tube etc. when I need to do a filament change?
Best Answer by kassi:
Ok, found it here: https://idc.dozuki.com/Guide/How+to+unload+and+reload+filament+from+the+Prusa+MK3+dry+box/6
Posted : 18/10/2023 6:59 pm
Topic starter
answered:
RE: Filament change due to spool empty - how
Ok, found it here: https://idc.dozuki.com/Guide/How+to+unload+and+reload+filament+from+the+Prusa+MK3+dry+box/6
Posted : 19/10/2023 6:50 am