Notifications
Clear all
2nd (and following) layer mess
Hello,
I'm currently trying to print a bigger-than-average (at least for me) model on my vanilla MK4. First layer goes well, without any obvious defects. And them a little bit of pandemonium comes into the print. Here are three photos of two different prints. The first one shows the fourth layer, the other two ones have been stopped at the second layer.
And I also get a shitload of « filament stuck » errors, which I never ever got previously.
Printing Rosa3D PLA filament, 220°C first layer, 200°C other layers.
Any idea ?
Thanks.
Posted : 21/08/2025 11:36 am