Notifications
Clear all
Problems with infills on 0.6mm nozzle
Hi
I have printed long time with 0.4 nozzle with no issues. Reasently I changed to 0.6mm nozzle and started to have problems with infills. Every perimeters works fine as far as I have tried with default print settings (0.15 struct -> 0.32 speed). But when ever it tries to print any infills my MK4 starts under extruding(?). I haven't seen this issue with any 0.4mm printer settings.
I have currently 6.4.0+11974 firmware , but I think that I had same issues with earlier firmwares also.
I am using PrusaSlicer -2.9.4:
- 0.15mm Structural
- Generic PETG
- MK4 Input Shaper 0.6
Posted : 04/01/2026 12:58 pm