Notifications
Clear all
Top Layer has little gaps, maybe under-extrusion ?
Hello people 🙂
finally I finished my assembly of my MK4 and my first prints looked very good besides one thing I noticed. The top layer shows little gaps between the printing lines.
I used Prusament PLA for this, 20% infill, Input Shaping. Besides infill i didn't changed anything in the PrusaSlicer. I think it started very well to cover the top layer but then it showed the gaps. Got the same on the upper top layer but its out of focus on my image so you cant see it :). Any hints? Did I tightened a screw a bit to much or to less?
Posted : 28/01/2024 11:27 am