Notifications
Clear all
Sheet cover ripped off with TPU (flex) print
Hey everyone,
I am printing some inland TPU (flex) from the Micro Center here in the USA. When I printed Benchy the print was super stuck to the plate and when removing the print it pulled off some of the cover on the smooth steel Prusa sheet.
I did print directly on the sheet with no glue.
Why and how can I prevent this from happening again?
thanks,
JM
Posted : 27/10/2023 7:01 pm
RE: Sheet cover ripped off with TPU (flex) print
If you check out the Prusa Material Table for Flex filaments it advices you to always use Glue Stick on the smooth sheet.
Posted : 27/10/2023 8:40 pm