Printing issue after replacement the xbuddy board - Assembly and first prints troubleshooting

RE: Printing issue after replacement the xbuddy board

ChiefSmeg — Thu, 02 May 2024 14:44:18 +0000

Ah good to know - you never know who else may do something similar. Glad you are all back up and running now!

RE: Printing issue after replacement the xbuddy board

3DPrintableArts — Thu, 02 May 2024 14:22:51 +0000

Yes, issue resolved.

It turns out my son installed the fan upside down, which prevented it from cooling the print properly.

RE: Printing issue after replacement the xbuddy board

ChiefSmeg — Thu, 02 May 2024 12:32:22 +0000

You ever manage to get to the bottom of this problem?

RE: Printing issue after replacement the xbuddy board

ChiefSmeg — Thu, 25 Apr 2024 21:47:40 +0000

There is definite over extrusion there. I’m sorry mate but I have no idea what the hell is happening here, have you tried Prusa again?

RE: Printing issue after replacement the xbuddy board

3DPrintableArts — Thu, 25 Apr 2024 14:35:53 +0000

Yes I'm using latest firmware 6.0.0 also tested previous versions and I get same results.

RE: Printing issue after replacement the xbuddy board

ChiefSmeg — Thu, 25 Apr 2024 13:56:49 +0000

Have you tried reflashing the latest firmware?

RE: Printing issue after replacement the xbuddy board

3DPrintableArts — Thu, 25 Apr 2024 13:25:40 +0000

Prusa replaced the faulty board, as the old one wasn't updating firmware beyond 2.1.5. Their team was very helpful and sent me a replacement board.
All wiring is correct, and the printer moves and operates as it should.

The only issue I'm facing is the print quality problem visible in the photos.

RE: Printing issue after replacement the xbuddy board

ChiefSmeg — Thu, 25 Apr 2024 13:01:25 +0000

Ok, so it would seem that this would be related to your change of buddy board as this is the only thing you changed. Need a bit of background here - why did you need a replacement has it ever run ok?

have you confirmed that all the cables are plugged back in correctly?

I know that last is a bit of a basic question to ask, but we need to rule out the obvious before moving into deeper problem solving

🙂

Printing issue after replacement the xbuddy board

3DPrintableArts — Thu, 25 Apr 2024 12:54:01 +0000

Since replacement the board from Prusa, I've encountered an issue. please review the attached photos.

I've performed calibration and tested multiple filaments, but haven't had any success.

Here are the settings I'm using:- Generic PLA profile setting- Temperature: 215°C extruder, 60°C bed- Layer height: 0.2 mm- Firmware version: 6.0

Do you think this problem could be related to the new board?