Notifications
Clear all
PCCF parts
Kind of a Public Service Announcement:
I just finished assembling a Mk4 with parts printed in PC-CF. No issues to speak of, with one exception: The two parts of the Y-belt holder. Due to the lack of elasticity of the PC-CF, I could not for the life of me get the belt into the cutouts on those parts. I ended up reprinting it in PETG. Also, the y-rod ends. Careful tightening the M3-10 screws that hold them to the rods, or they'll crack.
But otherwise, it felt easier to assemble than the Mk3S. I've been printing for three days non-stop, zero issues so far. And it is super QUIET, even without a paver stone.
Formerly known on this forum as @fuchsr -- until all hell broke loose with the forum software...
Posted : 16/07/2023 7:51 pm
gglockner liked