Notifications
Clear all
My 3.5S loses its mind after every 8-9 prints
First, I wish it were easier to set up a camera with Prusa Connect like I had with OctoPrint. Then I could record what is happening.
I upgraded my MK3S+ to a MK3.5S a couple weeks ago. I've been super happy with the result. Prints faster, more accurately, more consistently...except when it doesn't.
My printer is in a room where I can here it, but not see it.
I've been printing dozens of these, two at a time ( https://www.printables.com/model/652158-modular-wine-rack)
I'll get 5 or 6 print cycles perfectly. Then, I'll hear the print head crashing against one of the uprights, or maybe the plate. I go to look at the printer, and the print head has gone back to Z=0. It's ripped the model off the plate and is just oozing out filament.
Thoughts?
Posted : 18/11/2024 6:43 pm