Notifications
Clear all

Filament Not Sticking After Upgrade to 3.5  

  RSS
kuixote
(@kuixote)
Member
Filament Not Sticking After Upgrade to 3.5

My insanely reliable MK3S has turned into a non-adherence nightmare post-upgrade completion.  I've washed the bed carefully using dish soap  and iso (multiple times), reinstalled firmware and completed multiple calibration and live z adjustment attempts.  I've also tried multiple different filaments (PLA and PETG).   Nothing has worked.

 I suspected low bed temp (since I did the changed the bed thermistor as part of the uprade), but it's been passing the the temp checks.

I haven't called support yet - figured to try this first if there was a solution I was missing.    Other Ideas?

 

Posted : 31/12/2024 7:13 pm
Share: