Notifications
Clear all

Top Layer Pattern Question  

  RSS
jt
 jt
(@jt-3)
New Member
Top Layer Pattern Question

I understand how to change the top layer pattern, but I have a question about rectilinear. When I choose this I like the pattern, but the printer skips around and does different sections. I would like it to start at one spot and go all the way across. Is this possible with rectilinear? Thanks.

Posted : 11/12/2018 5:12 am
JoanTabb
(@joantabb)
Veteran Member Moderator
Re: Top Layer Pattern Question

good morning,

I have never found a way to linear-ise rectilinear top infill

regards Joan

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK

Posted : 11/12/2018 8:40 am
Share: