test 11 out - General discussion, announcements and releases https://forum.prusa3d.com/forum/english-forum-general-discussion-announcements-and-releases/test-11-out/ Prusa3D Forum Discussion Board en-US Sun, 12 Apr 2026 23:05:44 +0000 wpForo 60 RE: test 11 out https://forum.prusa3d.com/forum/english-forum-general-discussion-announcements-and-releases/test-11-out/#post-779011 Wed, 21 Jan 2026 07:12:16 +0000 You probably posted in the wrong forum section by accident. I see that you already have a few posts in the French Core One forum. That's where this post should go; with the context there you can probably get better responses.

The filament sensor calibration checks both sensors -- the one in the Nextruder and the one on the right side panel. Can you tell which sensor is causing a problem? 

]]> General discussion, announcements and releases Jürgen https://forum.prusa3d.com/forum/english-forum-general-discussion-announcements-and-releases/test-11-out/#post-779011 test 11 out https://forum.prusa3d.com/forum/english-forum-general-discussion-announcements-and-releases/test-11-out/#post-778951 Tue, 20 Jan 2026 21:58:51 +0000 Bonjour les Makers 

Titine a presque passer tous les tests Mais elle a callé au 11ème

capteur bien cablé ,donc a voir

]]> General discussion, announcements and releases Laurent https://forum.prusa3d.com/forum/english-forum-general-discussion-announcements-and-releases/test-11-out/#post-778951