RE: Review: Duramic PETG
@minimays
Does not sound flammable to me.
--------------------
Chuck H
3D Printer Review Blog
RE: Review: Duramic PETG
Well, I ran a scientific method and tried burning the filament with a lighter. It burned and started on fire, but would not stay on fire when I took the lighter away. 🙂
Thank you for the feedback. Would you say it was in any of the categories mentioned here:
https://www.protolabs.com/resources/blog/flame-retardant-thermoplastics-and-ul-classifications/
RE: Review: Duramic PETG
I'm going to throw this up here on an old thread for anyone who had second layer issues with this filament using the Mk4S and a .8 HF Nozzle - the flow rate is too limited on this filament for that combo, unless you dial the speed way down from the generic PETG settings - probably to 60% or so.
RE: Review: Duramic PETG
Nix that, I just realized I printed it with a HF nozzle profile and I had actually put in the regular .8 nozzle. <Facepalm>
I'm going to throw this up here on an old thread for anyone who had second layer issues with this filament using the Mk4S and a .8 HF Nozzle - the flow rate is too limited on this filament for that combo, unless you dial the speed way down from the generic PETG settings - probably to 60% or so.