Notifications
Clear all

Prusa Slicer 2.9.3 Organic supports.  

  RSS
John Lindo
(@john-lindo)
Trusted Member
Prusa Slicer 2.9.3 Organic supports.

Are there settings available in the Print settings  "support" menu that will alter the organic tip diameter, branch angles, density etc ?

The  defaults for example of the final tip diameters in some of the long supports some 150 mm tall seem to measure 0.8 mm, 

and these snap of long before they do there function of supporting open air horizontal faces.

I have been looking at another slicer that does include "TREE" features to accommodate my above question, but I have not tried this out yet.

 I am trying to stick with the Prusa slicer, I do not want muddy the waters especially in my 80 year old brain by having to relearn the behaviour of menus and sub menus of yet another slicer.

 

 

Posted : 09/10/2025 5:17 pm
Steve
(@steve-5)
Estimable Member
RE: Prusa Slicer 2.9.3 Organic supports.

John,

There are myriad options for modification of support application.  To see many of them you must be in "expert" mode in slicer (pull down on the top, right corner of the slicer window).  

Regards,

Steve

Posted : 09/10/2025 8:21 pm
Share: