Notifications
Clear all
Poor infill
I'm using a rectilinear infill at 15%. I'm getting poor infill with pockets. Any idea what parameters I can adjust?
Posted : 03/01/2025 8:42 pm
Probably a poor choice of fill for that part, try cubic. There are some signs that your filament is damp too.
Cheerio,
Posted : 04/01/2025 9:36 am
Topic starter
answered:
RE: Poor infill
Thanks. I'll try a different fill geometry. The filament was just taken out of its original vacuum-sealed wrapper for this run.
Posted : 04/01/2025 2:43 pm