Notifications
Clear all
One of multiple miniatures always fails when printing
Hello,
I am new to this forum and recently bought a Prusa I3 MK3S+ for printing mostly miniatures/props for tabletop gaming. Hopefully I am putting this post into a correct place. I have noticed, that when i am bulk-printing my minies, i always get a failed print on bottom-left of the centre of my build plate. The issue always starts in the middle of a miniature. I have added photos of my last skeleton print, hopefully someone could hint whats going wrong and how to fix this issue. The rest of minis just have some stringing and leftover debris from the failed miniature, nothing hard to clean.
Posted : 03/03/2022 10:11 am
RE: One of multiple miniatures always fails when printing
Hey,
as a first try i'd recalibrate the printer and set a slightly (about 2-5%) higher extrusion multiplier and a smaller layer height.
Posted : 03/03/2022 8:41 pm