Notifications
Clear all

LIGHT gray/grey PLA in USA?  

Page 2 / 2
  RSS
cwbullet
(@cwbullet)
Member
RE: LIGHT gray/grey PLA in USA?
Posted by: @jsw

This is 3d Elec Tech, an off-brand, but it prints fine and is a good match to a spool of Hatchbox which I could not find when it ran out.

https://www.amazon.com/gp/product/B08KSWV94B/ref=ppx_yo_dt_b_asin_title_o02_s00?ie=UTF8&psc=1

I will try that.  Thanks.   

--------------------
Chuck H
3D Printer Review Blog

Posted : 17/04/2021 11:29 pm
MartinLui
(@martinlui)
New Member
RE: LIGHT gray/grey PLA in USA?

I do not believe that you cannot find the right glue in the internet

Posted : 01/06/2021 8:57 pm
jsw
 jsw
(@jsw)
Famed Member
RE: LIGHT gray/grey PLA in USA?

If you're talking about glue for 3d pieces, for a firm bond I use Mike's Model and Craft glue.  It's similar to the Super Glue products.  For a more forgiving bond I use Aileen's The Ultimate Multi Surface Adhesive.

Here's the link for Mike's: https://www.drmikesglue.com/

Aileen's can be purchased at Michael's here in the States.

Posted : 01/06/2021 9:25 pm
MartinLui
(@martinlui)
New Member
RE: LIGHT gray/grey PLA in USA?

i think you should better try mod podge glue. You can add dye of any color. Or leave the glue colorless

Posted : 02/06/2021 1:11 pm
VINICIN
(@vinicin)
New Member
RE: LIGHT gray/grey PLA in USA?

@martinlui

I heard about it, it is quite good, but i think it is too expensive. I read reviews about mod podge glue. But I've never heard of dyes being added to glue. Does not it spoil the quality of the glue? If you did, please tell us more

This post was modified 4 years ago by VINICIN
Posted : 02/06/2021 3:38 pm
saltbayfour
(@saltbayfour)
New Member
RE: LIGHT gray/grey PLA in USA?

the colors must have Pantone values to make such a comparison; fortuantely most of them do jfi.cam/jiofilocalhtml/

This post was modified 4 years ago by saltbayfour
Posted : 26/06/2021 11:56 am
Page 2 / 2
Share: