Idea for enhancement - Ability to use cancel object to cancel the wipe tower
While you might want to use the wipe tower, sometimes it sadly detaches from the print bed. If you could use cancel object to just cancel the wipe tower then your print might be able to finish, I mean sure it would have whatever artifacts are introduced by not having a wipe tower, but that would be better than what happens as it extrudes fillament into the air and it hangs from the nozzle an goes all over the place.
Best Answer by Neophyl:
You mean this feature request that was made on the Prusa Slicer github page (the proper place for requests for changes to the software) https://github.com/prusa3d/PrusaSlicer/issues/11615
RE: Idea for enhancement - Ability to use cancel object to cancel the wipe tower
You mean this feature request that was made on the Prusa Slicer github page (the proper place for requests for changes to the software) https://github.com/prusa3d/PrusaSlicer/issues/11615
RE:
thanks for sharing