Notifications
Clear all

holographic bed steel plate  

  RSS
Zfrenchy
(@zfrenchy)
Trusted Member
holographic bed steel plate

Hi all,

 

I just received an holographic print bed sheet, then I print something on it with PETG, everything went nice, no bed adhesion issues, but ...When looked the printed part I can see the holographic effect (little stars) happy, but after clean up just with my fingers, the effect is gone !

That happen to somebody ?

Posted : 17/07/2024 12:30 am
Diem
 Diem
(@diem)
Illustrious Member

Holographic effects require surface precision closer than half the wavelength of light - within a few nanometers - just brushing an unprotected surface can be enough to destroy it. You may be able to protect it with lacquer, varnish or resin.

Cheerio,

Posted : 17/07/2024 2:21 pm
2 people liked
Share: