Force Measurement -- direct method - General discussion, announcements and releases https://forum.prusa3d.com/forum/english-forum-general-discussion-announcements-and-releases/force-measurement-direct-method/ Prusa3D Forum Discussion Board en-US Wed, 22 Apr 2026 11:00:53 +0000 wpForo 60 Force Measurement -- direct method https://forum.prusa3d.com/forum/english-forum-general-discussion-announcements-and-releases/force-measurement-direct-method/#post-712507 Fri, 31 May 2024 23:07:00 +0000 When trying to diagnose issues with bearings, smooth metal rods, or lubricants, I've found it helpful to directly measure, record and monitor the force required to move the Y-axis Assembly.  I've measured the force required to (a) pull a rod through one bearing; (b) pull a rod through two bearings; (c) pull a rod through two bearings mounted firmly into the Y-Frame.  Measurements are typically between 40g to 120g, well within the dynamic range of this inexpensive spring force gage.   This tool is available at:  https://www.amazon.com/gp/product/B00VYNT6Q6

]]> General discussion, announcements and releases Curt Will https://forum.prusa3d.com/forum/english-forum-general-discussion-announcements-and-releases/force-measurement-direct-method/#post-712507