Firmware 6.5.6 Removed Already
What the deal? The firmware was released only for a few hours and then taken down.
Core One L MMU3, MK3S
RE: Firmware 6.5.6 Removed Already
What the deal? The firmware was released only for a few hours and then taken down.
Arrghh, just updated the whole fleet few minutes ago...
RE: Firmware 6.5.6 Removed Already
Guess they found a last minute show-stopper bug. @kachidoki you should probably revert.
RE:
Glad Prusa pays attention to the forum
https://www.reddit.com/r/prusa3d/comments/1tvtw9d/prusa_buddy_fw_656_retracted/
https://www.reddit.com/r/prusa3d/comments/1tvsk49/dont_install_the_github_fw_for_mk4s_from_today/
Core One L MMU3, MK3S
RE: Firmware 6.5.6 Removed Already
It looks like the issue is specific to the MK4S. Mine starts up normally, so I’ll wait for the next version.
Version 6.4.2 was released at the same time for the XL. The release notes are brief, but I’ve noticed an improvement in the user interface. When you select tools to rearrange the filaments, the selected print head lights up. But I also found a bug right at the start of the first print, when switching to the left screen, the printer status overlaps the information.
RE: Firmware 6.5.6 Removed Already
The first hint from the dev team points to older xBuddy revisions.
Fortunately, since I’ve already sold my first MK4, my oldest remaining printer is an MK4S. Wait'n'see.
RE: Firmware 6.5.6 Removed Already
I wonder why Prusa people answers on reddit but never waste a second on their own forum...
RE: Firmware 6.5.6 Removed Already
I wonder why Prusa people answers on reddit but never waste a second on their own forum...
Hopefully that changes when we get new forum software!!