Filament spool too wide - General discussion, announcements and releases https://forum.prusa3d.com/forum/english-forum-general-discussion-announcements-and-releases/filament-spool-too-wide/ Prusa3D Forum Discussion Board en-US Sat, 14 Mar 2026 13:35:26 +0000 wpForo 60 RE: Filament spool too wide https://forum.prusa3d.com/forum/english-forum-general-discussion-announcements-and-releases/filament-spool-too-wide/#post-764278 Sat, 13 Sep 2025 17:17:09 +0000 Maybe find someone locally and offer a spool swap? :D

]]> General discussion, announcements and releases _KaszpiR_ https://forum.prusa3d.com/forum/english-forum-general-discussion-announcements-and-releases/filament-spool-too-wide/#post-764278 Filament spool too wide https://forum.prusa3d.com/forum/english-forum-general-discussion-announcements-and-releases/filament-spool-too-wide/#post-764274 Sat, 13 Sep 2025 16:04:03 +0000 I have a new spool of Prusament but it won't fit into my AMS or my dry boxes because the spool itself is ever so slightly too wide. 

All my other Prusament spools have been fine - its just this one which seems it wasn't pushed together properly from factory. 

Of course I can't push it together any further now because it's wound with a full spool of filament. 

Is there anything else I can do other than manually wind the entire 1kg of filament onto another spool, which would not only take ages, but is super tedious!

I know there are mechanisms and spool winders I could print, but I'd rather not print an entire solution for a single spool.......

Ideas?

]]> General discussion, announcements and releases iftibashir https://forum.prusa3d.com/forum/english-forum-general-discussion-announcements-and-releases/filament-spool-too-wide/#post-764274