RE: Can't I write a Private Message?
If you search
Prusa knowledge base
Then prusa slicer. You should find the user guide
Regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
RE: Can't I write a Private Message?
have you seen this?
https://help.prusa3d.com/category/prusaslicer_204
regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
RE: Can't I write a Private Message?
Hallo Ma. THX for your answer how compile the firmware to MINI+. I was looking for many months ago, but nobody help me. Now I looked and find your help with firmware compile. THX. But when I was do everithing what you nicely wrote, then it is not on my power correctly compiled. I have a big request for you, if you will doing the compiled the firmware for MINI+ with my "Configuration_MINI.h" for me and send me back. The file is update and get from Prusa firmware Buddy 5.1.2. I would be extremely grateful.
I am attaching the file in the attachment.
THX so much Pospi LEE
beb922cf-configuration_mini.h
I should answer this question but I cannot because I have only 3 posts made and this is the fourth 😉
RE: Can't I write a Private Message?
Hi Ma.
could you make a quick post to overcome the limit?
Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
RE: Can't I write a Private Message?
I have to say that I'm not entirely happy with the limitation of private messages to users with at least five forum posts. I was contacted by a user and couldn't even reply. Now I had to look for him on printables and answered him there in the hope that it was actually him.If the accounts are automatically linked anyway, you could also activate them based on the printables level or activate them automatically when a message is received.
Incidentally, I have already written 6 posts, of which only 4 are counted for reasons I cannot understand. Have I posted in the wrong forums? Am I not allowed to switch between German and English forum? Are the posts too old? Then only 3 should count, etc.
There is no communication about this. I'm not even told why I can't answer, just that I can't.
This is an extremely poor performance.
Let's see after how many posts I'm actually activated and whether I'm allowed to reply to German members or only to members from the English part of the forum. 😒
Printing PLA and PETG at the same time? See the Guide for MultiMaterialSupports ----- Ejecting Buffer cassettes is not satisfying? May the Fork be with you!