Tweaking settings
Hi Guys,
So I have been following the advice I have been receiving about fixing my settings in Slic3r for printing. So now I have spider webs between my prints and gaps. I have uploaded a few pics of whats coming out and am using the Prusa I3 Mk3 was using the 0.2 print setting.
One of the pics is from the inside, and the pic of the straw tops (wooden supports) are not even printing as a straight thing. They are jagged on the sides. Any advice would be great cause my stuff started printing better, and now that I am trying to tweak things to make them as they should, they are printing worse (at this point thinking of unistalling Slic3r and reinstalling a clean one with pre sets)
Re: Tweaking settings
Hmm one file wouldnt upload on last message
Inside
Re: Tweaking settings
I've had this happen to me a couple of times when I get a new reel of filament. Create a simple cube object 20x20mm and 3mm high. Try a number of temperature settings. 210C may be too cold, 215C looks great, 218C looks like disaster. I suspect that your temperature setting is a bit too high, gumming up in blobs at times and creating thin wisps when making long moves.
Kg