Star Wars Death Trooper
😯 This is my last print. 😯
Printed with gray pla fabbrix. You can see the video for the print details.
video link
link project
https://www.myminifactory.com/object/death-trooper-32710
https://www.youtube.com/watch?v=https://www.youtube.com/channel/UCik5i3_Be2QQe7LcK2Mv5Ig Italian student and just youtube. Passionate about 3d printing and technology
Re: Star Wars Death Trooper
I want it 🙂
Re: Star Wars Death Trooper
Wow looking great!
Re: Star Wars Death Trooper
Just a question. Does that print the whole skull inside the helmet or are the helmet and skull one mesh? I only ask because while printing a figure once it printed a foot inside a boot but the boot completely covered the foot. Is there an easy way to join meshes in the slicer? Or do I need to engage in more pre-print work?
Thanks,
Neal
Re: Star Wars Death Trooper
Try Mesh Mixer as pre-slicing work.
Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage or loss. If you solve your problem, please post the solution…
Re: Star Wars Death Trooper
Mesh-Mixer...gotcha...and thanks a load.
Neal