I made a thing! Perfect if you want Octoprint + Raspberry Pi for your i3
http://www.thingiverse.com/thing:1325370
/Sascha
Re: I made a thing! Perfect if you want Octoprint + Raspberry Pi for your i3
Hi Sascha
Great, thanks for this. Well done!
Peter
Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…
Re: I made a thing! Perfect if you want Octoprint + Raspberry Pi for your i3
Really nice Sascha!!
I was going to do something similar for my OctoPi, but now I'm just going to use your design.
Looking forward to see what you come up for a camera mount.
Roger
Re: I made a thing! Perfect if you want Octoprint + Raspberry Pi for your i3
I saw this earlier! I already printed one out! Just waiting for my Rasberry Pi to come in. Looking forward to being able to remotely monitor my growing printer farm 😛
Re: I made a thing! Perfect if you want Octoprint + Raspberry Pi for your i3
http://www.thingiverse.com/thing:1325370
Great design! I tweeted about it here https://twitter.com/josefprusa/status/697845767420170240
Re: I made a thing! Perfect if you want Octoprint + Raspberry Pi for your i3
http://www.thingiverse.com/thing:1325370
Great design! I tweeted about it here https://twitter.com/josefprusa/status/697845767420170240
Awesome! Thanks.
/Sascha
Re: I made a thing! Perfect if you want Octoprint + Raspberry Pi for your i3
Now i gotta go buy some orange filament so i can make one (cant have it not matching the pretty Prusa Orange 😛 )
Re: I made a thing! Perfect if you want Octoprint + Raspberry Pi for your i3
This is amazing! I hadn't heard of Octoprint before. I have a Pi laying around, guess I'll have a use for it once I get through my current printing load.
Re: I made a thing! Perfect if you want Octoprint + Raspberry Pi for your i3
And here is a simple clip to help with the power cable management.... http://www.thingiverse.com/thing:1352384
Re: I made a thing! Perfect if you want Octoprint + Raspberry Pi for your i3
And here is a simple clip to help with the power cable management.... http://www.thingiverse.com/thing:1352384
I printed this yesterday and it looks really nice on the frame as a difference from the zipties I used. Here is my first attempt at doing a Octoprint timelapse while I was printing your design 🙂
https://www.dropbox.com/s/q8fzorea6evbu40/usb_cable_clip_20160218211608.mpg?dl=0
/Sascha
Re: I made a thing! Perfect if you want Octoprint + Raspberry Pi for your i3
I made one as well, thanks for creating it. I'm using it now with AstroPrint. Case looks great, need to get new cables to clean it up a bit.