Baby Groot
Prusa i3 MK3 kit
FW: 3.1.1-RC5-150 / Driver ver.: 2.1.3 (05. 01. 2018)
Source: https://www.thingiverse.com/thing:2014307
Size: 15,5 mm (height)
Layer: 150 um
Infill: 20% (grid)
Supports: No
Print time: 11:42
Re: Baby Groot
Really looks great with all of the iissues people are having. When did you get your MK3 and did you have any printing issues?
Re: Baby Groot
Really looks great with all of the iissues people are having. When did you get your MK3 and did you have any printing issues?
I picked up my MK3 kit on 25th of January and built it with the official manual (where are all important tips - highly recommended read every line of instructions). After the build run the wizard and since calibration no issues, zeros in fails statistic - so far so good.
Only missing some minor features (linear advance, etc.), but PEI metal plate, high speed, very low noise is the best. Devs hard working on new stable. I saw some problem of layer shifts, but I guess it is more mechanical problem than FW. Devs hard working on new stable FW every day (see GitHub), so we just have to wait some time to full features enabled.
PS: Another test with 3DBenchy:
